cmos logic input
Moderators: David Barker, Jerry Messina
cmos logic input
To use one of the cmos level logic inputs, is there any special command needed aside from declaring the pin an input? I need to use port a pin 4 as a cmos level input to read a signal from an ignition coil. (the signal has been conditioned with a 4.7V zener diode)
Dear hgboy,
In my project, since I don't use analog signal, I will use:
There's documentation on SetAllDigital in the help file under library "utils.bas". Also see the Wiki page on the same title.
Hope it helps.
Regards,
Liak
In my project, since I don't use analog signal, I will use:
Code: Select all
SetAllDigital
Input(PortC.4)
Hope it helps.
Regards,
Liak