I need to send simple data from one pic to another.
I read somewhere that "connect TX of the PIC1 to the RX of the PIC2, an you're set".
How is the data sent and read? Do I use the USART.Write -command to send data and then from the other pic I test the PIR1.5 to read data?
I need to configure baudrate but what else do I need to configure? I tried reading the USART-module, but I coudn't figure it out.
pic to pic communication
Moderators: David Barker, Jerry Messina
- Senacharim
- Posts: 139
- Joined: Tue Aug 10, 2010 5:19 pm
- Location: Ventura, CA